Jack is highly recommended though, because it allows you to use several Jack based audio applications at once with the ability to route audio between them. Jack is more advanced, but also harder to set up and may have to be installed manually. On Linux you have the choice between ALSA and Jack. Device Type: Determines the sound driver that Renoise will use.For general questions and FAQs regarding sound output on Linux, take a look at the Linux FAQ. Setting up Linux for fast and reliable audio usage can be quite complex, depending on the distribution you are using. Higher numbers will reduce the possibility of crackling sound at high CPU usage, but will also cause more latency (the time it takes the sound from Renoise to reach an output and be heard). Latency: Set the buffer size affecting overall latency.Out Device: If you have multiple soundcards installed, you will be able to select the one you want to use with Renoise here.In Device: If you have multiple soundcards installed, you will be able to select the one you want to use with Renoise here.Reinitialize: Shut down and then reopen all connections to the soundcard/driver.Control Panel: (ASIO only) Opens the ASIO driver's control panel where you can configure your soundcard in more detail.Dithering: Apply dithering to the audio stream when the soundcard uses a bit depth of 8 or 16 bit.This may lead to better performance when you don't need the other channels. Limit to stereo in/out: (ASIO only) If you have a multi-IO soundcard, you can disable all inputs and outputs except for the main stereo pair.If you experience strange results then disable this function. If you enable this option, then experiment with recording in the Sampler before deciding to use it permanently, as it may cause issues. Use hardware buffers: (DirectSound only) This option may speed up playback processing a bit, but only some soundcards support this.It is only necessary to set this if Renoise cannot reliably detect the actual output latency of the audio device. Sync offset: A custom offset applied when synchronizing audio playback to an external source such Ableton Link peers.Latency: (DirectSound only) Set the buffer size affecting overall latency.The higher the Sample Rate, the more detailed the results will be, but also the more CPU power will be used. ![]() All internal audio processing in Renoise will be done at this rate.
0 Comments
Leave a Reply. |